Follow the steps below to reset the oil change service warning. Resetting the oil change service light follows the exact same procedure as the inspection warning Give it a light spray of WD40 and reconnect, and then use a plastic cable tie around the connector to hold it very firmly. Mike. I have followed the above last weekend due to the airbag light appearing on the dash last Thursday morning. I extinguished it with a code reader/eraser and it came back on Thursday evening.

I drive Skoda Octavia 2011 1.4 TSI Elegance edition. From some days, airbag warning light popped up in the dash board. Following info retrieved with the help of diagnostic tool:

Skoda Octavia airbag warning light - if this light comes on during normal vehicle operation it indicates a probem within the Octavia airbag system or module. You can find out where the problem is by using the iCarsoft i908 Skoda OBD Code Reader which will locate the problem. Once the problem is located and fixed the light can be removed.
Bought a vag com for £65.00 from ebay cleared the light . Did keep coming back on a day ot two after clearing the code . Understood that the Octavia's have problems with airbag wiring under seat . I unbolted the seats fiddled with the wiring . Reset the light and 3 months later light still has not come back on .
Today I had to remove the front passenger seat from my Skoda Octavia so I could get a fridge freezer in. Only issue is that I had to unplug the airbag that was in that seat so the car is now complaining. Does anyone know the way to reset the airbag system to rectify this fault? I need to get it sorted soon as the MOT is due in about 2 months.
The heater fan speed controller is not a thyristor and it's not a relay, it's just a resistor. On a Mk1 Fabia the battery does not need disconnecting and the passenger airbag does not need touching to replace the resistor. You just remove the glovebox, which is dead easy. He disconnects the battery in this video but there is really no need.
\n how to reset airbag light on skoda octavia
The ABS light comes on in the dashboard of Skoda Yeti when one or more of the wheel speed sensors have malfunctioned, brake fluid is too low, the fuse is blown or the relay is bad, tire pressure is low, or if the ABS module has developed a defect. When the ABS light / comes on in your Yeti, the anti-lock braking system is disabled. Hear are the tips how to succeed to reset this warning light using a special scan tool and OBD II code. At first you must check why your air bag light is on, to do this connects the diagnostic tool to your car and then go to control units, -> body and then scroll down to the meniu MRS multiple restrant system or SRS and press ok button. If an airbag is disconnected and the ignition is then turned on, the light will appear, with the light on ALL of the airbags are disconnected, not just the one that was disconnected (or the one where there is a fault). Unfortunately disconnecting the battery will not reset the light, it's now VCDS or dealer time. 22.3k.

How to reset service interval on Skoda Octavia 2nd Generation simple and fast DON'T forget to Comment LIKE and SubscribeRemise à zéro du compteur / indicateu

.
  • f3we6phb15.pages.dev/363
  • f3we6phb15.pages.dev/85
  • f3we6phb15.pages.dev/250
  • f3we6phb15.pages.dev/447
  • f3we6phb15.pages.dev/222
  • f3we6phb15.pages.dev/177
  • f3we6phb15.pages.dev/359
  • f3we6phb15.pages.dev/91

    • how to reset airbag light on skoda octavia